Drilling Laboratory

Petroleum Engineering Main Building – Ground Floor

Drilling Laboratory

The Drilling Laboratory focuses on measuring the physical and rheological properties of drilling mud, such as viscosity, yield point, gel strength, density and lubricity. In addition to drilling mud, measurements are also made on the cement mixture, such as measuring its consistency. This laboratory is used by third year students, with supervision from final year students.

The Drilling Laboratory is equipped with the following equipment:

Standard Equipment

• 1 Low speed Mud Mixer
• 2 Multi Mixer
• 1 Low speed Mud Mixer
• 20 Mud cup

Determination of the Rheological Characteristics of Water-Based Sludge

• 1 Mud Balance
• 1 High pressure Mud Balance
• 3 Sets of Fann VG Viscometer Kit
• 2 HPHT Filtration Equipment
• 1 API Filter Press Equipment (LPLT Filtration)

Determination of Relative Viscosity, Sand Content, and Lubricity of Water-Based Mud

• 7 Marsh Funnel
• 1 Baroid EP Lubricity Tester
• 5 Set Perangkat Sand Content Tester

Determination of the Rheological Characteristics and Stability of Oil-Based Mud Emulsions

• 4 Aging cell
• 2 Rolling Oven
• 1 High pressure Mud Balance
• 2 OFI Retort Kit
• 1 ES Tester + Zener Diode
• 2 Fann VG Thermal Cup
• 3 Fann VG Viscometer

Determination of Setting Time, SBS and CS from Cement Mixture

• 1 Mud Balance Apparatus
• 2 Cement Mixer
• 2 Konsistometer
• 1 Container Water Heater
• 1 Hydraulic Press

 

 

Safety and Security Equipment (K3G)